DECOPOX micro mortar kit for supports with humidity

The kits are made up of the following products:

PREPARATION OF THE SUPPORT

The concrete supports must be solid, dry (completely set if they are newly built 28 days), level, absorbent, not contaminated with oils, detergents, powders or other substances.

Evaluate the most suitable type of mechanical preparation, clean the support with a hydro-cleaning machine or rough it with the use of an abrasive, polishing machine.

Oily surfaces have to be thoroughly devastated and treated, with Pavex 2C Primer + quartz already mixed or by dusting until saturated on the fresh product.

On non-absorbent substrates (ceramic, marble ...), devastate, sand and vacuum, then apply one pass with Ecopox Cem Plus 3C.

On bases without guarantees of stability, create a reinforcement, adding to the system a fiberglass mesh.

APPLICATION GUIDE

Tri-component product: Join component A (Epoxy Resin) and component B (hardener) in the cuvette, mixing with a mixer at low speed for approximately 2 minutes. Then add component C (Special Cement) and mix for 2 more minutes.

Dilute with 15% by weight with clean, fresh water, apply with the appropriate trowel, the consumption is approximately 400 - 500 g / m² per coat.

Before proceeding with the coating, wait 24 hours (at 25 ° C and 50% relative humidity), consult the hygrometer to be completely dry. In the case of results indicating the presence of moisture, apply additional layers of Ecopox-Cem Plus 3 C, until complete drying is obtained.

INSTRUCTIONS FOR USE ECOPOX CEM PLUS 3 C - STEAM BARRIER

• Mix components A + B with a whisk at low speed for at least 2 minutes, add component C and mix for 2 more minutes, until perfect homogenization is obtained.

• The application can be done with a steel, rubber ...

DECOPOX SPATULA APPLICATION

Pour the contents of part B over part A, shake and mix with a low speed whisk. Add dilution water and continue mixing until a completely homogeneous mixture is obtained, then pour the content C (color pigment) and mix again until obtaining a homogeneous mixture again. Apply with a trowel without loading two layers with a consumption per layer of 500 - 600 g / m2.

The amount of pigment with respect to component A + B can vary between 1 to 10% depending on the color effect to be obtained.

Decopox Spatula, can be used to obtain decorative floorings with various effects, for this type of application consult the indicative cycles or request the technical assistance service.

• Mix the components A + B with a whisk at low revolutions for at least 1 minute, until obtaining a perfect homogenization. Subsequently, incorporate component C (Color and mix again at low revolutions until obtaining a homogeneous product,

• The application can be done with a steel, rubber ...

VELADURA APPLICATION

Pigment the product with 1 or 2% of Universal Tint (if you want color) and homogenize with the use of a low-speed mixer drill.

Apply the material with a trowel at an approximate consumption of 100 g / m² per coat.

Avoid creating very thick films.

Delays can be generated in the development of its final characteristics, specifically deep drying and sensitivity to water.

• Stir with a whisk at low revolutions for at least 2 minutes, until obtaining a perfect homogenization.

• The application can be done with a steel, rubber ...

IMPORTANT

For shades of yellow, orange or some reds, additional layers may be needed to obtain a good coverage (in some cases a first pass in white is recommended). Different production batches of the same color may have small differences, so it is recommended to use material from a single production batch.

Some organic pigment-based colors (reds, blues, greens, and deep yellows) tend to fade when subjected to abrasion (either dry or wet). In these cases it is advisable to protect the color with a clear finish coat.