Escríbeme un Whatsapp
  • Online only

Ecopox Cem Plus 3C Vapor Barrier Waterproofing Mortar and Mortar

€41.49
Tax included
Ask a question (0)
Capacity
Color
Quantity

Ecopox Cem Plus 3C is a back pressure waterproofing that acts as a PERFORMANCE BARRIER to prevent WETNESS BY CAPILLARITY as well as to seal cracks in stucco, slab cladding or other cladding both on walls and on concrete floors.

WATCH VIDEO APPLICATION ON CERAMICS

WATCH VIDEO APPLICATION ON CONCRETE

Characteristics of the Ecopox Cem Plus 3C

The water-based epoxy resin is modified with aluminized additives for the realization of an osmotic barrier and / or waterproofing membrane.

Application of the Ecopox Cem Plus 3C

  • Tri-component product: Join component A (Epoxy Resin) and component B (hardener) in the cuvette, mixing with a mixer at low speed for approximately 2 minutes. Then add component C (Special Cement) and mix for 2 more minutes.
  • Dilute with 15% by weight with clean, fresh water, apply with the appropriate trowel, the consumption is approximately 400 - 500 g / m² per coat.
  • Before proceeding with the coating, wait 24 hours (at 25 ° C and 50% relative humidity), consult the hygrometer to be completely dry. In the case of results indicating the presence of moisture, apply additional layers of Ecopox-Cem Plus 3 C, until complete drying is obtained.

How to use the Ecopox Cem Plus 3C

  • Mix components A + B with a whisk at low speed for at least 2 minutes, add component C and mix for 2 more minutes, until perfect homogenization is obtained.
  • The application can be done with a steel, rubber trowel ...

Support preparation for the Ecopox Cem Plus 3C

  • The support surface affected by humidity must be carefully cleaned, removing paint, plaster, salts, as well as cement, grease, chemical products, loose particles and coatings with poor mechanical anchorage.
  • On new setting concrete> 28 days.

Technical data of use of the Ecopox Cem Plus 3C

  • Application temperatures: 10-30ºC and humidity less than 75%
  • Consumption: 400 - 500 g / m² (1 layer)
  • Color: Dark Gray
  • Packaging: Pack of 25 kg
  • Dosage between the components: A = 100, B = 50, C = 100
  • Flash point: Not applicable
  • Dry to touch (50% humidity): 10 ° C: 20-24 hours 25 ° C: 8-10 hours 35 ° C: 4-6 hours
  • Pedestrian (50% humidity): More than 24 hours (25 ° C)
  • Adhesion to concrete: More than 3.5 N / mm 2
  • Tool Cleaning: Water
  • Conservation:
    • Componenete C 6 months.
    • Components A and B 12 months.
    • Store in a dry place at a temperature between 5 ° C and 35 ° C and sheltered from the elements and humidity.

SIM00190

Specific References

New product

Be the first to write your review !

No customer questions for the moment.


Your Question has been successfully sent our team. Thanks for question!
Ask a question
hide form
Captcha