Putty High resistance Interior-Exterior

Repair and filler putty

- Normal setting
- Excellent adherence
- Controlled retraction mortar
- High resistance
- On absorbent funds
- Without fissures

APPLICATIONS /

- Especially indicated for the repair of all types of masonry flaws.

- Repair Facades, cornices, recessed, partitioning ...

- For grouting, covering gaps and cavities on absorbent cementitious bottoms.

- For aesthetic repairs on concrete, walls, tunnels ...

- Indoors and outdoors

SUPPORTS SUPPORTED /
- Concrete and cement mortars
- Brick, stone partitions ...
- Semi-absorbent bottoms

OBSERVATIONS /
- The support will be free of saltpeter, fungi ...
- Do not add water when the mass begins the setting process.
- Do not apply where the water can remain stagnant.
- When a second coat needs to be applied, apply before the first coat has set.

EMPLOYMENT CHARACTERISTICS /
- Rest time after kneading: 5 min.
- Life of the dough: 2 h. (20ºC)
- Minimum thickness: 1 mm
- Thickness per layer: 10 mm
- Thickness to fill: unlimited
- Start of setting: 1h 15 min.
- Set End: 1h. 45 min.
* These times can vary considerably depending on the ambient temperature

RECOMMENDATIONS FOR APPLICATION /
- Application temperatures between 5 - 30ºC

- Do not add any product to the mortar

- Do not apply in a permanent state of heat, since the product could lose its benefits.

- The application of the
product on old paints, plasters ... that can come off with the application of the mortar.

- Do not use by casting for fillings.

- Do not apply on non-absorbent funds.

EXECUTION CONDITIONS /

- The supports must be healthy, stable and resistant, free of dust, plaster, paint ...

- Eliminate the deteriorated and degraded parts, until reaching the solid, resistant and absorbent support.

- Powdery surfaces must be
consolidated with F-600.
- All areas subject to stress (expansion joints, encounters of different materials ...),
They must be reinforced with fiberglass or metal mesh.

- On surfaces without absorption, very smooth or poorly absorbent, strip and open pore to ensure good adhesion.

- Avoid applying the coating in low temperatures, strong humidity, rain ...
hours following the application of the mortar increases the risk of the appearance of
carbonation efflorescence.

HOW TO USE/
- Kneading: Mix a bag of MASILLA (25kg) with 7.75 - 8 liters of clean water until obtaining a homogeneous mass and without lumps.

Using the product within its useful life, after this time it could lose the initial benefits.

Coat with alkaline-resistant and vapor-permeable paints.

BENEFITS /
- Apparent density in powder: 0,875 g / cm3
- Mass density: 1,250 g / cm3
- Mixing water: 31%
- Adhesion to wood: 0.5 MPa
- Adhesion on Ceramic: 0.6 MPa
- Adhesion on iron: 1 MPa
- Adhesion on Pladur: 0.13 MPa
- 28 day compression: 9 N / mm2
- Flexotraction: 9.3 N / mm2
- Water absorption: 0.15 Kg / (m2 · min0.5)
* These results have been obtained under standard conditions and may vary depending on the installation.

PRESENTATION /
25 kg paper bags, anti-humidity.
1200 kg pallets (48 bags)

CONSERVATION/
12 months from the date of manufacture, in original closed container and sheltered from the elements and humidity.