Micropool Micromortar Pool Kits - With waterproofing

Products that make up the kit

6 m² KIT

Units Packaging Product

1 1 Lt. F300

1 5 Kg. THICK FIBRATED MICROPOOL

1 5 Kg. FINE MICROPOOL

2 1 Lt. ALIPHATIC POLYURETHANE

Weight 13 Kg

20 m² KIT

Units Packaging Product

2 1 Lt. F300

1 25 Kg. THICK FIBRATED MICROPOOL

1 25 Kg FINE MICROPOOL

1 5 Kg ALIPHATIC POLYURETHANE

Weight 80 Kg

60 m² KIT

Units Packaging Product

1 5 Lt. F300

3 25 Kg. THICK FIBRATED MICROPOOL

2 25 Kg MICROPOOL FINE

2 14 Kg ALIPHATIC POLYURETHANE

Weight 185 Kg

100 m² KIT

Packaging Units Product

2 5 Lt. F300

4 25 Kg. THICK FIBRATED MICROPOOL

3 25 Kg MICROPOOL FINE

2 14 Kg ALIPHATIC POLYURETHANE

Weight 215 Kg

120 m² KIT

Packaging Units Product

2 5 Lt. F300

6 25 Kg. THICK FIBRATED MICROPOOL

3 25 Kg MICROPOOL FINE

2 14 Kg ALIPHATIC POLYURETHANE

Weight 263 Kg

Application and method of use of Micropol 

Mix the components A + B with a whisk at low revolutions for at least 1 minute, until obtaining a perfect homogenization. The application can be carried out with a steel trowel, rubber ... Prepare the mixture of the 2 components (A + B) pour the content of component B into the container of component A, stir the mixture and homogenize with the drill at low revolutions . Apply the product with the appropriate trowel at an approximate consumption of 450 - 550 g / m² per coat. To color the product use water-based dyes, the amount of dye with respect to the product (A + B) can vary from 3% to 10%, depending on the desired color effect.

Uses of the product Micropol 

• Coating with "spatulate" effect for exterior surfaces.
• Pavements and coatings in light colors.

Information about the stand for Micropol 

The support must have a minimum mechanical resistance to compression of 25 N / mm2 and tensile strength of 1.5 N / mm2. The concrete supports must be solid, dry, level, absorbent, not contaminated with oils, detergents, powders or other substances.

• On new setting concrete> 28 days.
• Evaluate the most convenient type of mechanical preparation (using an abrasive machine, polishing machine or hydro-cleaner) and apply one pass of Transparent Paviplast Epoxy.

• Performance of the Micropol 3C mortar
• • Specific gravity (25ºC): 180+ / -0.05g / ml.
  • Viscosity (25ºC): thixotropic paste.
  • Dry residue: 84.3% by weight and 50% RH.

  * These results are from standard tests and may vary depending on the on-site conditions.

Important information for the product Micropol 

Colors with shades of yellow, orange or red may require more applications to achieve a good coating effect (in some cases a first recovery of white is recommended). Multiple production batches may have slight color differences: If possible, use material from a single production batch. Some organic pigment-based colors (reds, blues, greens, and deep yellows) tend to fade when subjected to abrasion (either dry or wet). In these cases it is advisable to protect the color with a pass of transparent Paviplast Transparent finish.