Pavifer anti-corrosion mortar

ANTICORROSION MORTAR

DESCRIPTION

Special cement, micronized aggregates, fibers, additives and resins.

EXECUTION CONDITIONS

• The supports must be healthy, stable, resistant and free of dust, greases, oils ...
• Remove the deteriorated concrete by grinding and mechanical cleaning, until obtaining a healthy surface to receive the Pavifer .
• With rusty reinforcements, mechanical cleaning (sandblasting) will be carried out until the complete removal of non-adherent oxide.
• It acts as a bridge to receive the Pavigrout .
• Pavifer cannot be seen.
• Indoors and outdoors.

BENEFITS

• Powder apparent density: 1.3 g / cm 3 .
• Mixing water: ± 25% .
• Mass density: 1.5 g / cm 3 .
• Pasta life: 30 minutes .
• Time between layers: 3-4 hours (20ºC) .
• Total setting: 24 hours (20ºC) .
• Fire behavior: A1 Euroclass .

* The times and benefits are contemplated at 20ºC and may vary depending on the ambient temperature.

HOW TO USE

• Mix Pavifer with 20% clean water + 5% F-300 until a smooth and lump-free mass is obtained.

• The percentage of water may vary depending on the mixer used. • Apply Pavifer with a brush or brush in layers of 2-3 mm per pass.