- Online only
STYLFLOOR colored and decorative self-leveling
Self-leveling colored mortar for the construction of decorative floors adhered in new construction or rehabilitation. Public works, department stores, hotels…. For floors where high planimetry is required. Moderate light and heavy traffic. Indoor.
Floor screed , mortars and concretes with high resistance to compression (> 35 N / mm2). On cement-based substrates ...
Recommended from 10 to 12 mm (specific areas, maximum thickness of 15 mm).
Polished. RECOMMENDATIONS FOR APPLICATION Always respect the same percentage of water during mixing. Do not add any additive to the mortar. Respect the minimum thickness required according to the types of support. Respect, perimeter joint (min. 5 mm), expansion (16-20 m2) and fractionation. Application temperatures 5ºC to 30ºC.
The support must be solid and hard, be dry, free of dust, from broken areas, paints, oils ... Do not apply to cracked, degraded concrete or with the possibility of movement ... In all cases, on new concrete (set> 28 days ) or old and compression> 25 N / mm 2 , mill the surface layer until the aggregate appears. On weak cementitious bases and without guarantees, mill until the aggregate appears, vacuum and reinforce with Silicate Hardener . On Floor screed , sand, open pore and vacuum, before pouring and final finishing. Avoid application with drafts. Before pouring, apply 1 - 2 passes of F-300 Quick Primer. Respect the expansion joints, work, by cutting or placement of profile (maximum cloths, 16-20 m 2 ).
HOW TO USE
- By pumping: percentage of water 20 - 21%.
- If necessary, use the barbed roller to remove the air trapped in the dough and achieve a better leveling.
- Dry polishing:> 7 days.
** This product is considered in the experimental phase until it constitutes an annual history. From then on, the newly designed product was considered consolidated and suitable for use in its sector. Meanwhile, the manufacturer reserves the right to adapt its specifications, modifications or application ranges, according to technical criteria and improvements.
Do not apply on: Exterior floors. Wet floors subject to continuous humidity lifts. Degraded, fragile or unstable soils. On underfloor heating in service (stop the heating 24 hours before and start up after 48 hours after finishing the work).
Kneading and transport by pumping. Life of the mass: 10-20 minutes Start of setting: 45 minutes Dry to the touch: 5-7 hours Passable (pedestrian):> 8 hours Time for dry polishing:> 7 days.
* These times can vary considerably depending on the ambient temperature.
PERFORMANCE Mixing water (in the laboratory): 21% Flexural strength (28 days): > 10.0 N / mm 2 Compressive strength (28 days): > 40.0N / mm 2 Wear Böhme UNE-EN 13892 -3: 17.9cm 3 / 50cm 2 Wear UNE-EN 13748-1: <20.0 mm Adhesion to concrete: 1.3 N / mm 2 Impact resistance, UNE-EN 12633:
** Drop height: > 1500 mm
** IR value: IR = 14.7 N • m
Adhesion on ceramic support: 0.98 N / mm 2 Designation: EN 13813: 2003 - CT-C40-F10-A22
* These results are from standard tests and may vary depending on the on-site conditions.
25 kg paper bags, anti-humidity.
1200 kg pallets (48 bags)
12 months from the date of manufacture, in the original closed container, protected from the elements and humidity.
* Floor screed , self-leveling mortar for screeds indoors.
* Pavistamp-Floor Colored, self-leveling colored mortar for interior floor decoration.